|
| Sub Menus - For more in depth categories, we have categorized in the following list! |
HOME > CASE
|
This special edition features fine chrome works all over the case, detachable hand holder and LED lit-up Dagger logo. The dummy glass button has been pre-modded for possible LED lighting by users. You need to see to appreciate its beauty!
The Logisys "Dracula" gaming case gives you a whole different attitude for gaming cases. On one side of the case is a great window to allow you to show off all the goodies inside your case. Open the front panel and you will see the four 5.25" bays and the two external 3.5" bays. The front panel has a devil’s look to it which brings out the toughness of this case. Both sides of the case feature a 3D wing design to add to the Dracula theme. The eyes of this case light up bloody red when the power is on. Towards the bottom of the front bezel is what looks like a mouth. Buried under that front mouth design are front USB and audio ports. An 80mm Quad LED fan is included on the side window along with a stylish 80mm Blade II Fan grill. Around back is a pre-installed 120mm fan for you case to cool down even more. There is room up front for an optional 80 ~120mm fan. Inside the case, you will find four 3.5" internal bays and a standard motherboard tray.
|
- Dimension: 200mm(W)x440mm(H)x500mm(D)=7.9"x17.3"x19.8"
- Fits All standard ATX motherboard and Micro ATX motherboards
- 4 open 5.25" drive bays
- 2 open 3.5" drive bays
- 4 hidden 3.5" drive bays
- A total of 10 bays
- Built in 2 front USB 2.0+Audio Output
- 1 Firewire Connector
- Back Mounted 120mm clear fan and 80mm Red LED fan. Also, a blade 2 fan grill is included
- Acrylic Side Window
Special Designed Shutter Style Air Exit for better and silent performance
- Toolless Thumb Screws
- The case has a special designed detachable handle bar come with the case
Instruction to install the Dracula Case Handle
- 1. Do not hook up the computer cables. Unplug any power supply cables, if connected.
- 2.Remove the 2 thumb screws holding the side panel.
- 3. Remove the side panel by sliding it backward.
- 4. Unscrew the 4 screws holding the power supply at the back panel and remove the power supply.
- 5. Put the rectangular holding plate inside the case beneath the top panel. Align the position so the 2 screw could reach the plate with the 2 screw-threaded holes.
- 6. Put the Handle on top of the case. The side with the lamp should close to the front.
- 7. Insert the 4 screws and tighten the handle to the plate. Care should be taken not to over tighten it.
- 8. Install the power supply back into the position, with the 4 screws.
"The Dracula Cases, Phantom Cases,3D edge fan and Stove Fan are Registered TradeMark which are protected by US Trademark Law"
|
|
|
